SAGINAW, MICHIGAN AREA
ADULT TRUCK DRIVER
TRAINING
ADVANCED COMPLIANCE SOLUTIONS
ADVANCED COMPLIANCE SOLUTIONS, LLC
TELEPHONE: (989) 752-8183
FAX:
(989) 752-8310
Office Hours: Monday-Friday
A.C.S. has developed this course especially for the inexperienced driver. The program has been designed for Class A and B commercial vehicles. The training can include any necessary endorsement offered by the State.
All training is set up on the basis of one Instructor to one Student; equipment; instructor travel expenses; materials, depending upon program selected.
The curriculum is as follows:
A. PRE TRAINING STUDENT EVALUATION:
The instructor shall determine if the appropriate course has been selected for the student via an initial evaluation. If difficulties are anticipated for training procedures, equipment type, or time frames, the student and/or employer shall be informed prior to continuation of the training program. If it is determined that training must be modified, or training must be terminated, the student (or employer), as it applies shall be responsible for any time, equipment rental, and/or materials involved.
B. INITIAL EVALUATION AND INSTRUCTION:
INSPECTION/MECHANICAL KNOWLEDGE - The program provides review of locations and explanation of components for safe operation and use of the commercial vehicle type to be utilized during the training program. Mechanical knowledge includes parts of the vehicle necessary to perform a thorough vehicle inspection and inspection details. (Components will vary depending on the equipment type.) Instruction on developing a "systematic method" to ensure complete vehicle inspections will be included in the curriculum.
SKILLS - Demonstrations, instruction, and practice for specific maneuvers for operating the equipment will be included in this segment of the training program. There will be concentration on areas of individual weaknesses. Maneuvers contained in the program include, but are not limited to: Forward Stops; Backing; Straight through; Alley docking; Right and Left turns; and/or parallel parking.
EQUIPMENT HANDLING - The student will be expected to operate the equipment properly; double clutching; and learning to shift smoothly. Any special equipment will be reviewed with the student as necessary. Equipment handling instruction will include, but not limited to: Clutching; Gear Usage; Braking; Steering; Turns; Traffic Laws; Defensive driving; and/or Seat Belt usage.
REVIEW - Prior to continuance of training, the instructor will review and analyze the progress of the student. The elements utilized to make this determination will include attitude, ability, confidence, and proficiency demonstrated by the student. (This evaluation will normally be completed within the first day of training.) The student and/or employer will be advised at this point of the recommendations of the instructor for the continuance of the training program. A decision will be made (mutually between the student/employer and the instructor) whether or not to continue with the training program. (This determination does not serve as a guarantee that the student will pass the program.) The intention of the initial evaluation and instruction segment is to be used as a guide for the student and the instructor.
C. COMPLETION OF TRAINING PROGRAM:
DRIVING - "On the Road" training will not commence until the initial evaluation has been completed and the instructor is confident that through discussion and/or exercises performed, that the student is prepared to continue. After the student has reached a comfort level in the "off-road" environment, they will be given an opportunity to drive in real traffic situations. The student will be expected to follow very specific criteria such as: Turn approaches (stop if necessary; turning procedures; and completing turns); Intersections (stopping; driver awareness; driving through); Urban/Rural (maneuvers; lane changes; curves; railroad crossings; bridges/overpasses); Stop/Start (approach; stop and resume); Expressway (merge; straight; lane changes, and exits), etc.
INSPECTION/MECHANICAL KNOWLEDGE - Continued review of locations and explanation of components for safe operation and use of the vehicle type will occur.
SKILLS - Continued demonstrations, instruction, and practice for specific maneuvers while operating equipment will be included in this segment of the training program - with concentration on areas of individual weaknesses. The skills included will be as listed previously, but not limited to these skills.
EQUIPMENT HANDLING - The instructor will continue to review the proper equipment handling; double clutching, and learning to shift smoothly. Again, any special equipment will be review with the student if necessary.
D. FINAL REVIEW:
At a point when the instructor and student agree that the student is prepared, the instructor will review and analyze the progress of the student. The elements utilized to make this determination will include attitude, ability, confidence and proficiency demonstrated by the student throughout the training program. The student and/or employer will be advised at this point as to the recommendations of the instructor for the final testing and evaluation.
E. QUALIFICATION:
The necessary skill test can be scheduled through A.C.S.
IMPORTANT NOTICE: Training cannot be initiated without the following original documents:
A. CDL/TIP VALIDITY -- Prior to the initiation of the training, the Instructor must verify that the student holds a valid Temporary CDL. (Additional training programs are available through A.C.S. to assist the student in preparing for the State written tests. This is offered at an additional fee.)
B. PHYSICAL QUALIFICATION -- The Instructor shall verify that the driver holds a current and valid DOT medical card, prior to the initiation of the training. (A.C.S. has a listing for available vendor options.)
C. The student will provide proof of a 'Negative' DOT drug screen. (A.C.S. has a Substance Abuse Testing Program available for this testing.)
D. The student must hold a current, valid driver's license.
IMPORTANT NOTICE: If the training cannot be conducted due to lack of any of the above listed items, no refund shall be issued.
PROPOSED PRICING:
The estimated training time for the program proposed is based on the program that is selected (See Pricing). The designated time frame for each training course is estimated. More time may be required, dependent upon the student's ability and adaptability. If more than the selected days are required for the training; the additional time; materials and/or equipment will be billed according to the daily rates.
*** FULL TRUCK DRIVER TRAINING PROGRAM (2 Week): $ 6,495.00
- Classroom - 20-24 Hours (Logbook, Equipment operation, Defensive Driving, Load Securement, Basic Regulations, Other Specialized Topics, etc.)
- Range/Road - 48-52 Hours (Basic Control Skills, Equipment Handling, On-road driving)
- Equipment
- Certificate of Completion
*** CATEGORY 1 Truck Driver Training Program (1 Week):
- 5-Day Training and Equipment Rental $ 3,315.00
- 5-Day Training (No equipment) $ 2,375.00
*** CATEGORY 2 Truck Driver Training Program (3-Day):
*Not Recommended for Class A Vehicle Training
- 3-Day Training and , Equipment, CDL Test $ 1,845.00
- 3-Day Training, (No equipment) $ 1,325.00
*** REFRESHER Truck Driver Training Program (1-2 Day):
- Training, 1 CDL Test and Equipment $ 599.00/Day
- Training, 1 CDL Test only (No equipment) $ 499.00/Day
- 1/2 day Training (includes: 2 hrs instruction, 1 CDL Test and Equipment) $ 425.00/ 1/2 Day
*** A Non-refundable deposit of $500 is required to hold appointments. The Non-refundable deposit of $500.00 must be received at least 10 business days prior to the training; with the balance paid "in full" prior to the initiation of the training. Written cancellation must be received by A.C.S. at least 5 business days prior to training in order to qualify for a refund, less the $500 deposit.
** A Non-refundable deposit of $250 is required to hold appointments. The Non-refundable deposit of $250 must be received at least 10 business days prior to the training; with the balance paid "in full" prior to the initiation of the training. Written cancellation must be received by A.C.S. at least 5 business days prior to training in order to qualify for a refund, less the $250 deposit.
The driving record of each individual instructor is available for review upon request.
Notice: This school is required to be licensed by the Michigan
Department of State, Driver Training and Testing Division. If you
have a complaint which you cannot settle with this school, write:
Michigan Department of State, Driver Training and Testing Division, Post
Office
Advanced Compliance Solutions,
L.L.C.
1621 Terminal Drive
Saginaw, MI 48601